Defender 110 (LD) V8-3.9L (1993)
Front Door Window Regulator: Service and Repair
Window Regulator - Front Door
Service Repair No - 76.31.45
Remove
1. Remove door trim casing.
2. Remove plastic sheet.
3. Temporarily fit handle, position window half open and support with a length of timber.
4. Remove 2 lower screws securing mounting panel to door and slacken 3 upper screws.
5. Remove 4 screws retaining window regulator to mounting panel and slide operating arms from channels attached to glass and mounting panel and
remove regulator.
Refit
6. Insert regulator operating arms into channels.
7. Fit and tighten mounting panel lower screws and tighten upper screws.
8. Align holes in regulator with holes in mounting panel and secure with 4 screws.
9. Temporarily fit regulator handle and check that glass can be raised and lowered without tight spots.
10. Secure plastic sheet.
11. Fit door trim casing.