Defender 110 (LD) V8-3.9L (1993)
6.
Remove engine mounting bracket bolt and attach bracket PRC2979, refit and tighten bolt to 38 ft.lbs (52 N-m) (refer to illustration).
7.
Re-route engine harness and secure in position with tie wrap UKC6684 (refer to illustration).
8.
Reconnect harness to coil, alternator, A/C fan temperature switch, compressor, water temperature transducer and oil pressure switch transducer
connector.
9.
Torque the manifold to downpipe nuts to 22 ft.lbs. (30 N-m).
10.
Turn on battery master switch.
PARTS INFORMATION
The parts are available as Kit Number D/C822. The kit can be ordered through the Memphis warehouse using your Parts system. The kit contains these
items:
STATUS CHECKING/VEHICLE IDENTIFICATION
You may check the disposition of any vehicle using the Land Rover terminal Warranty Recall/Search screen. Complete and install a Service Campaign
label and clear acrylic cover on the underside of the engine hood near the emissions label.
A completed example of this label is shown.