Defender 110 (LD) V8-3.9L (1993)
17. Turn in worm adjuster while rotating shaft to increase figure measured to 0.56 Nm (0.41 ft. lbs.).
18. Back off worm adjuster 1/4 turn. Turn in worm adjuster to increase reading found in step 14 by 0.21-0.34 Nm (0.15-0.25 ft. lbs.) with locknut
tight, 100 Nm (74 ft. lbs.) Use worm adjusting wrench tool No. LRT-57-006 and locknut wrench tool No. LRT-57-028.
19. Screw slave bolt into piston to aid assembly.
20. Install piston and rack so piston is 70 mm (2.75 inch) from outer end of bore.
21. Install sector shaft using seal saver tool No. LRT-57-021. Align roller with cut out in casing. Push in sector shaft while rotating input shaft to allow
sector roller to engage worm.
22. Install rack adjuster and thrust pad to engage rack. Back off half turn on adjuster.
23. Loosely install new nylon pad and adjuster set screw assembly.
24. Install new sealing ring to cover.