Defender 110 (LD) V8-3.9L (1993)
Anti-Roll Bar Links: Service and Repair
Front
Front Stabilizer Bar Link
Service Repair No - 60.10.02/60.10.04
Removal
1. Raise vehicle on a ramp.
2. Remove 2 nuts, bolts washers and rubber bushes from ball joint links.
3. Remove cottor pin and loosen castellated nut a few turns.
4. Release link joint using tool LRT-57-018 as shown.
5. Remove castellated nut and link.
Installation
1. Fit link and castellated nut. Ensure ball joint link arm points up. Tighten nut to 40 Nm (30 ft. lbs.) and fit new cottor pin.
2. Align stabilizer bar to links.
3. Fit bolts, washers and rubber bushes using new self locking nuts and secure stabilizer bar to links. Tighten fixings to 68 Nm (50 ft. lbs.).
4. Lower vehicle.