Defender 110 (LD) V8-3.9L (1993)
11. Remove 5 bolts and separate hub from brake disc.
WARNING: A maximum of two road wheel retaining studs can be renewed. Should more studs be unserviceable install new hub with
studs.
12. Remove grease seal and inner bearing from hub.
13. Remove inner and outer bearing tracks (races).
Installation
1. Clean hub and install inner and outer bearing tracks (races).
2. Pack hub inner bearing with grease and install to hub.
3. With lip side leading install a new seal flush with rear face of hub. Using service tool LRT-99-003 seal replacer and LRT-54-003 drift. Apply
grease between seal lips,
4. Assemble brake disc to the hub, line up reassembly marks. Applying sealant Part No. STC 50552 to the threads of retaing bolts, install and tighten
retaining bolts to 73 Nm (55 ft. lbs.).
5. Pack hub outer bearing with grease and install to hub.
6. Clean stub axle.
7. Install hub assembly to stub axle.