Defender 90 (LD) V8-4.0L (1997)
Canister Purge Control Valve: Service and Repair
EVAP CANISTER AND PURGE CONTROL VALVE
Remove
1. Remove 3 clips securing purge pipe to coolant hose.
2. Depress tags and disconnect purge pipe from plenum chamber.
3. Remove PAS reservoir clamp bracket bolt.
4. Open clamp and release reservoir from bracket.
5. Remove 2 nuts securing bracket to wing.
6. Release bracket from wing and disconnect multiplug from purge valve.
7. Release clip and disconnect fuel tank vapor separator pipe from canister pipe.
8. Move PAS reservoir aside, release and remove charcoal canister, purge valve and bracket assembly.
Do not carry out further dismantling if component is removed for access only.
9. Remove bracket from purge valve.