Defender 90 (LD) V8-4.0L (1997)
Liquid Vapor Separator: Service and Repair
VAPOR SEPARATOR
Remove
1. Remove 7 screws securing floor carpet rear retainer.
2. Release lower section of door sealing rubber on one side.
3. Remove carpet retainer.
4. Fold floor carpet back on RH side.
5. Release RH side carpet and move aside to reveal 2 screws securing vapor separator.
6. Remove 2 screws securing vapor separator.
7. Release vapor separator pipe from clip on fuel pipe.
8. Depress 2 lugs on vapor separator connector and disconnect pipe.
9. Using tool LRT-19-002 depress collar at green end of "speedfit" connector and disconnect pipe.
10. Remove vapor separator.
Refit
11. Position vapor separator and connect pipes.
12. Using assistance, align vapor separator and fit and tighten screws.
13. Apply adhesive to side carpet and body.
14. Fold down side and floor carpets.
15. Fit carpet retainer and fit and tighten screws.
16. Secure door sealing rubber.