Defender 90 (LD) V8-4.0L (1997)
20. Remove circlip and seal from sector shaft housing bore.
CAUTION: The use of a seal puller is recommended to prevent damage to casing, and possible oil leaks.
21. Remove dirt excluder, circlip and seal from input shaft housing bore.
22. Discard all rubber seals and provide replacements.
Rubber Seals
NOTE: A rubber seal is installed behind plastic ring on rack piston. Discard seal and plastic ring.
23. Examine piston bore for scoring and wear.
24. Examine feed tube.
25. Install a new feed tube if damaged. Tighten union to: 20 Nm (15 ft. lbs.).