Defender 90 (LD) V8-4.0L (1997)
Wheel Bearing: Service and Repair
Front Suspension
Front Wheel Bearing and Wheel Hub - Vehicles Built Up To: 01/1999
Service Repair No - 60.25.14
Removal
1. Loosen road wheel nuts, raise front of vehicle and lower onto axle stands. Remove road wheel.
2. Release brake hose clips and remove brake caliper and brake disc shield bolts. Secure caliper to one side.
3. Lever off dust cap.
4. Remove circlip and driveshaft shim from driveshaft.
5. Remove 5 bolts and withdraw drive member and joint washer. Discard joint washer.
6. Bend back lock washer tabs.
7. Remove locknut and lock washer.
8. Remove hub adjusting nut.
9. Remove spacing washer.
10. Remove hub and brake disc assembly complete with bearings.
11. Remove outer bearing.
12. Mark, for reassembly, relationship between hub and brake disc, if original hub is to be reinstalled.
13. Remove 5 bolts and separate hub from brake disc.
14. Drift out grease seal and inner bearing from hub and discard seal.