Discovery I (LJ) V8-3.9L (1994)
/v8-3.9l/Page-1832003.png)
2.
Install the new seal, lip side first, into hub using tool # LRT-54-011 (figure 2).
3.
Clean stub axle. If applicable, retract ABS sensor slightly from sensor sleeve.
4.
Install hub assembly onto stub axle.
5.
Install spacing washer.
6.
Fit hub nut.
7.
Tighten hub nut to 50 Nm (37 lbf. ft.).
8.
Rotate hub assembly and ensure free rotation with no bearing play.
9.
Back nut off 90° and torque to 10 Nm (90 lbf. in.). This will give the required end play of 0.01 mm (0.0004 in).
10.
Fit locking tab washer.
11.
Fit second hub nut and tighten to 50 Nm (37 lbf. ft.).
12.
Lock both inner and outer nuts with locking tab washer.
13.
Using new gasket, install axle shaft into hub and secure with five bolts. Tighten to 65 Nm (48 lbf. ft.).
14.
Install brake caliper. Tighten to 82 Nm (60 lbf. ft.). Secure brake hose to axle housing.
15.
If applicable, push ABS sensor fully into bush until it touches sensor ring and rotate hub to set sensor.
16.
Install road wheel and tighten nuts to 126 Nm (93 lbf. ft.).
17.
Remove axle stands and operate foot brake to locate brake pads before road test.
