Discovery I (LJ) V8-4.0L (1996)
26. Using a cotton bud, apply Glass Primer (green cap) to inside face of glass, 20 mm strip around inside of finishers and 30 mm wide along bottom
edge. This must be touch dry before applying adhesive.
27. Remove protective coverings and tape.
28. Pierce top and pre-cut nozzle to sealer cartridge, remove lid and shake out crystals and install cartridge in applicator gun.
29. Apply a continuous bead of adhesive sealant around the glass as shown. Vertical edge of sealer to abutt finishers and to be 8 mm from bottom
edge of glass.
30. Remove protective covering (RED) from side finisher sealing strip.
31. With assistance: Attach suction cups to glass and lift into position, carefully align the indicators on the obscuration band with the supports. Lower
screen onto body flange, check alignment and firmly press to seat glass in the aperture.
NOTE: The finisher on later vehicles will not have cutouts, or supports fitted, as shown.
32. Align cut outs with the supports and push finisher fully onto the glass. Use a wooden block to ensure fit.
33. Refit 'A' post finishers and interior mirror.
34. Refit wiper arms.