Discovery II (LT) V8-4.0L (2002)
/v8-4.0l/Page-1542002.png)
4.
If the actuator rod is above or below the required length, perform the following steps:
^
Refer to RAVE, section 76.13.12 and remove the RH side load space trim casing.
^
Loosen actuator fasteners and adjust the actuator to obtain the required length on the actuator rod.
^
If the actuator rod is still above or below the required length, release the actuator from its fasteners and disconnect the actuator multiplug.
^
Use a round file or other suitable tool to elongate the actuator installation holes to permit extra adjustment as required.
^
Etch prime any bare metal prior to painting.
^
If required, repair body paint finish.
^
Install actuator and verify that actuator rod is at the required length.
^
Tighten securing nuts and connect the multiplug to the actuator.
5.
Paint the new fuel filler flap BPA000030 to the required body color.
6.
Install the new fuel filler latch BPX700010 and cushion FSU000010 to fuel filler flap. (Figure 2)
7.
Position fuel filler flap to vehicle and tighten screws.
8.
Check operation and alignment of new fuel filler flap and adjust if necessary.
9.
Refer to RAVE section 76.13.12 and install RH side load space trim upholstery.
