Discovery II (LT) V8-4.0L (2002)
/v8-4.0l/Page-1661007.png)
^
While holding the two halves of the twistgrip together, place the release strap in position (B in Figure 11) and secure with a new pin. (A Figure
11)
^
Place the ferrule onto the rotating half of the twistgrip assembly. (Arrowed Figure 12).*
^
Locate the twistgrip assembly to the frame brackets and secure with two Torx screws.
^* Place a 1.5 mm feeler gauge between the stationary and rotating halves of the twistgrip.
^
Push the stationary half of the twistgrip against the frame bracket. (Arrowed Figure 13)
^
Push the rotating half of the twistgrip up against the stationary half of the twistgrip. (Arrowed Figure 14)
^
Verify there is a 1.5 mm (0.060 inch)gap between the halves of the twistgrip.
^
Push the ferrule against the frame bracket while also pushing rotating half in opposite direction. (Inset Figure 14)
