Discovery II (LT) V8-4.0L (2002)
/v8-4.0l/Page-749002.png)
9. NAS models: Remove cable tie securing pressure sensor pipe to filler tube and remove filler tube.
Refit
1. NAS models: Position filler tube to pressure sensor pipe and secure with new cable tie.
2. Fit grommet to body, position filler tube under rear wing and secure in grommet.
3. NAS models: Connect filler tube to fuel tank and secure with clip. Connect vent pipes to filler tube.
4. All except NAS models: Connect filler hose and breather hose to filler tube and secure with clips. Connect vent pipe to filler tube.
5. Position support bracket to mud flap and secure with new rivet.
6. If applicable, re-fill fuel tank with extracted fuel.
7. Fit filler cap.
8. Remove stand(s) and lower vehicle.
