landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Drivetrain - Rear Differential Water Contamination|Page 3045 > < Pressure Plate|Specifications
Page 1
background image

Differential Case: Customer Interest
Drivetrain - Rear Differential Water Contamination

No:

51/01/02/NAS

Ref:
Issue:

1

Date:

08/09/02

Rear Axle Breather Extension

AFFECTED VEHICLE RANGE:

Discovery Series II (LT)

Up to 2A755880

SITUATION:

WATER CONTAMINATION IN AXLE OIL

Constant water spray or wading may result in ingress of water through the rear axle breather tube, contaminating the axle oil. Rear axle oil may be
observed to be pale in color when checking oil levels at service intervals. This indicates that the rear axle oil is contaminated with water.

RESOLUTION:

INSTALLATION OF ALTERNATE BREATHER HOSE

Vehicles that are frequently waded or driven in extremely wet conditions and have verified axle oil contamination should have the revised rear axle
breather components installed. The new parts permit relocation of the breather vent to a high point in the body structure. Follow the instructions in this
TIB for installation.

PARTS INFORMATION:

TVP000020 Breather tube,lower

Qty 1

TVP000030 Breather tube, upper

Qty 1

SYC000050 Clip

Qty 1 Vehicles with coil springs only

LRN7590

Gear Oil

Qty as required

WARRANTY CLAIMS:

51.20.89/27

Time 0.30 hrs.
Replace contaminated axle oil and install new breather tube system

FAULT CODE: B

Normal warranty policy and procedures apply. 
Material allowance is included in labor operation.

REPAIR PROCEDURE

INSTALL NEW BREATHER TUBE

CAUTION:

Connecting the two breather tubes together before being instructed to do so will result in the breather tubes becoming unusable.

1.

Refer to RAVE Workshop Manual, Maintenance - Front and Rear Axle, and replace axle oil.

WARNING:

Always support the vehicle on safety stands for your own protection.

2.

Raise the rear of the vehicle and support on safety stands.

3.

Locate the existing rear axle breather tube and remove as follows:

^

Remove and discard the cable tie securing the tube to the radius arm.

^

Clean the area surrounding the rear axle breather, disconnect the breather tube and move aside.

Drivetrain - Rear Differential Water Contamination|Page 3045 > < Pressure Plate|Specifications