Discovery II (LT) V8-4.0L (2002)
Gear Sensor/Switch: Service and Repair
Switch - High Low - Warning
Switch - High Low - Warning
Service repair No - 41.30.05
Remove
1. Raise vehicle on a ramp.
2. Release switch multiplug from bracket on transfer box and disconnect from harness.
3. Remove switch from transfer box and discard sealing washer.
Refit
1. Ensure sealing washer, switch thread and mating face on transfer box is clean.
2. Fit sealing washer to switch, fit and tighten switch to transfer box to 26 Nm (19 lbf.ft).
3. Connect multiplug to harness and fit multiplug to bracket on transfer box.
4. Lower vehicle.