Discovery II (LT) V8-4.6L (2003)
Alarm System Transponder: Service and Repair
Receiver - Alarm System - Models Without Sunroof
Receiver - Alarm system - Models Without Sunroof
Service Repair No - 86.77.31
Remove
1. Release rear door upper trim finisher.
2. Remove 3 Torx bolts securing rear headrest, remove headrest. Repeat operation on opposite side.
3. Remove both 'D' post trim casings.
4. Release rear interior light lens, remove 2 nuts to release light.
5. Release 2 studs securing rear headlining, carefully lower lining.
6. Remove 2 studs securing alarm receiver.
7. Disconnect multiplug from alarm receiver and remove receiver.
Refit
1. Connect multiplug to receiver.
2. Position receiver and secure with studs.
3. Position rear end of headlining, secure with studs.
4. Position interior light fit and tighten nuts.
5. Fit interior light lens.
6. Fit both 'D' post trim casings.
7. Fit 3 Torx bolts securing headrest and tighten to 25 Nm (18 ft. lbs.). Repeat operation on opposite side.
8. Fit rear door upper finisher