Discovery II (LT) V8-4.6L (2003)
Refit
1. Connect release cable to latch.
2. Position latch and motor assembly to door. Fit Torx screws securing latch to door and tighten to 7 Nm (5.2 ft. lbs.).
3. Connect multiplug to motor.
4. Connect exterior handle control rod to latch.
5. Connect sill button lock rod to latch.
6. Fit front door frame.
See Windows and Glass, "Windows / Window Glass." See: Windows and Glass/Windows/Window Glass
Rear Door Latch and Motor
Remove
1. Remove rear door frame.
See Windows and Glass, "Windows / Window Glass / Front or Rear Door." See: Windows and Glass/Windows/Window Glass
2. Release exterior handle control rod from latch.
3. Release sill button lock rod from door latch.
4. Disconnect multiplug from motor.
5. Remove 3 Torx screws securing latch and motor assembly to door.
6. Remove latch and motor assembly through lower aperture in door.