Discovery II (LT) V8-4.6L (2003)
^
Check for continuity between the ground stud C0561-1 and the black wire on the ABS modulator body connector C0500. (Figure 2)
^
If there is no continuity, or intermittent continuity when the wire is flexed, repair the damaged wire and ensure the splice is correctly crimped
and sealed.
CAUTION:
Connector pins must only be renewed one at a time to ensure the pins are returned to the correct position.
2.
Disconnect and check the 13-pin connector at the ABS modulator (C0501). (Figure 3)
3.
Disconnect the 15-pin connector C0506 at the Self Leveling and Anti-lock Braking (SLABS) ECU. (Figure 4)
4.
Inspect both connectors for moisture ingress or corrosion and correct as follows:
^
If moisture or corrosion is present, dry and clean the connectors.
^
Repair corroded connectors as necessary.
5.
With connectors C0501 and C0506 disconnected perform the following:
^
Check for continuity between pin 6 of the 15-pin SLABS ECU connector (C0506) and pin 9 of the 13-pin ABS modulator connector (C0501)