Discovery II (LT) V8-4.6L (2003)
Engine Mount: Service and Repair
Mounting - Rear - LH
Mounting - engine - rear - LH
Remove
1. Raise vehicle on ramp.
2. Position jack to support gearbox.
3. Remove 2 nuts and remove mounting.
4. Remove heat shield from mounting.
Refit
1. Clean mounting and mating faces.
2. Position heat shield to mounting.
3. Position engine mounting and tighten nuts to 85 Nm (63 in. lbs.).
4. Lower support jack.
5. Lower vehicle.