Discovery II (LT) V8-4.6L (2003)
Technical Service Bulletin # TEC300105
Date: 051110
Engine - Upper Intake Manifold Gasket Replacement
No: 30/01/05/NAS
FGN 303-12
Ref:
Issue: 1
Date: 10 November 2005
Revised Method and Time for Intake
Manifold Removal and Installation
AFFECTED VEHICLE RANGE:
Discovery Series II (LT) All with Secondary Air Injection (SAI) System
SITUATION:
CHANGE TO METHODS FOR REPLACEMENT OF THE UPPER INTAKE MANIFOLD GASKET
Methods engineers at Land Rover have recently studied the service process for renewal of the intake manifold gasket for Discovery II models.
Significant process changes have been made. The changes
refine and improve the process that allows the operation to be carried out more efficiently. Changes include:
^
Hood removal no longer required.
^
Hood seal no longer removed from engine bay.
^
Step added to remove the coolant inlet tube, easing removal of the intake manifold.
RESOLUTION:
FOLLOW NEW PROCEDURE FOR INCREASE EFFICIENCY
Should it become necessary to replace an intake manifold gasket on a Discovery II equipped with secondary air, refer to the repair procedure detailed in
this bulletin.
PARTS INFORMATION:
Refer to Microcat for parts required
DDW WARRANTY CLAIMS:
NOTE:
Associated repairs that require the new workshop procedure will also change. The superseded repair time for 30.15.24/25 was 1.80 hours
NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only.
Always refer to DDW to obtain the latest repair time.
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.
Normal warranty policy and procedures apply.