Discovery II (LT) V8-4.6L (2003)
Engine Control Module: Service and Repair
Engine Control Module (ECM)
Service Repair No - 18.30.01
Remove
1. Release fixings and remove battery cover.
2. Disconnect battery earth lead.
3. Remove fixings securing fascia RH closing panel, release diagnostic socket RH drive models, and remove panel.
4. Remove 2 fixings and remove A' post lower trim.
5. Remove 2 nuts and release ECM from studs and location on 'A' post lower panel.
6. Lower ECM into footwell and disconnect 5 multiplugs.
7. Remove ECM.
Refit
1. Position new ECM and connect multiplugs.
2. Fit ECM and secure with nuts.
3. Fit lower trim panel to 'A' post and secure with fixings.
4. Fit diagnostic socket to closing panel, fit closing panel and secure with fixings.