Discovery II (LT) V8-4.6L (2003)
/v8-4.6l/Page-95003.png)
7.
Perform the following: (5 in Figure 3)
^
Remove the Allen screw from the sensor
^
Release the ABS sensor from the front hub.
^
If the original 0-ring remains in the sensor bore, remove it and discard.
8.
Loosen four bolts securing the front hub to the swivel hub. (6 in Figure 4)
9.
Release the front hub from the swivel hub sufficiently to allow the ABS sensor harness to be removed. (7 in Figure 4)
10.
Clean the ABS sensor and mating surface, ensure any metallic particles are removed.
11.
Apply grease supplied in the kit to the ABS sensor.
12.
Lubricate new '0' ring on the new ABS sensor.
13.
Position the ABS sensor between the hub and the swivel hub.
14.
Tighten Allen screw to 18 Nm (13 lbf.ft).
15.
Position the hub and the tighten bolts to 100 Nm (74 lbf.ft).
16.
Secure the ABS sensor harness to the brackets and secure the grommet to the inner fender valance.
17.
Connect the multi-plug to ABS sensor harness.
18.
Install the front brake disc.
19.
Lower the front of vehicle.
ABS SENSOR REPLACEMENT PROCEDURE - REAR
1.
Raise rear of vehicle and support with stands.
2.
Refer to RAVE/GTR section 70.12.33 and remove the rear brake disc.
