Discovery II (LT) V8-4.6L (2003)
/v8-4.6l/Page-1296003.png)
2. Press in new bushes:
^
Use LRT-60-004/1, LRT-60-004/2 and LRT-60-004/3 to fit front bushes.
^
Use LRT-60-004/1, LRT-60-011/2 and LRT-60-011/3 to fit rear bushes.
3. Position radius arm to vehicle. Fit bolts and nuts but do not tighten at this stage.
4. Models with SLS: Position height sensor link to radius arm and tighten nut and bolt to 25 Nm (18 ft. lbs.).
5. Fit road wheel(s) and tighten nuts to 140 Nm (103 ft. lbs.).
6. Remove stand(s) and lower vehicle.
7. Tighten radius arm nuts and bolts to 230 Nm (170 ft. lbs.).
CAUTION: Nuts and bolts must be tightened with weight of vehicle on suspension.
8. Use Test Book to calibrate SLS height sensor.
