Housing for Gear Selector Mechanism - Manual Transmission Repair
Shifter M/T: Service and Repair
Housing - Gear Selector Mechanism
Housing - Gear Selector Mechanism
Service Repair No - 37.16.37.01
Disassembly
1. Remove 4 bolts and remove gear selector housing.
Reassembly
1. Clean mating faces on selector housing and gearbox.
2. Apply sealant, STC 3254, to selector housing.
3. Clean selector housing bolt threads.
4. Apply Loctite 290 to threads of selector housing bolts, position selector housing and tighten bolts to 25 Nm (118 ft. lbs.)
5. Adjust gear lever bias springs.