Discovery II (LT) V8-4.6L (2003)
/v8-4.6l/Page-1023021.png)
61. Position housing ensuring that output shaft and dog clutch splines - if fitted are correctly engaged.
62. Clean output housing bolt threads.
63. Apply Loctite 290 to threads of bolts.
64. Fit output shaft housing bolts and tighten in a diagonal sequence to 45 Nm (33 lbf.ft).
65. Fit output flange, new felt washer, steel washer and new retaining nut.
66. Using tool LRT-51-003 to restrain flange, tighten output flange nut to 162 Nm (119 lbf.ft).
67. If fitted - Operate differential lock selector lever and check that detent ball can be felt to positively engage/disengage with grooves in shaft. Screw
plug in or out until setting is correct.
68. Fit high/low selector shaft detent ball and spring.
69. Apply Loctite 290 sealant to threads of high/low selector shaft detent plug.
70. Fit and tighten plug, then loosen 2 complete turns.
71. Operate high/low selector lever and check that detent ball can be felt to positively engage/disengage with grooves in shaft. Screw plug in or out
until setting is correct.
72. Fit intermediate gear cluster.
