landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 4916 > < Diagram Information and Instructions|Page 4914
Page 6
background image

the information presented in a standard format. The connector number is displayed on each page header to ease reference. Connector information
comprises:

-

Connector Number - The assigned number, prefixed 'C'.

-

Connector Name - Usually derived from the component to which the connection is made.

-

Male/Female - If applicable, identifies the gender of the connector pins (NOT the housing) as Male or Female. Generally, connectors mating
directly into a component have Female pins.

-

Colour - If applicable, the color of the connector housing is shown. NATURAL is used to describe connectors with a clear/translucent plastic
finish.

-

Location Statement - Used in conjunction with the photograph to determine the location of the connector.

-

Photograph - Shows the location of the subject connector. In most cases the photograph will indicate the amount of trim removal necessary to
reveal the connector. For convenience some photographs identify more than one connector.

-

Face View - An outline of the connector housing, viewed from the front, showing pin numbers (if applicable).

-

Pin-out Table - A three column table, detailing the color and position of each wire in the connector:

1. Cav: The connector pin (cavity) number.
2. Col: The color of wire populating the connector pin.
3. Cct: Identifies the model or feature which uses the wire. 'ALL' means applicable to all models in the range fitted with the feature or system in

question. In instances where different models, features or systems require different color wires to be fitted in a cavity, each instance of the cavity is
included in the pin-out table.

NOTE:  Wires may not be fitted to all cavities.

Example - 12 Pin Connector

Where necessary, a table listing the circuit reference numbers against a description of the model or features which may or may not be fitted can be found
at the beginning of the connector section. A sample of a typical is shown below.

Cct

Model or Feature

1

3 Door

2

5 Door

3

LHD

4

RHD

5

Japanese vehicles only

6

NAS vehicles only

7

Australian vehicles only

Diagram Information and Instructions|Page 4916 > < Diagram Information and Instructions|Page 4914