Freelander (LN) V6-2.5L (2004)
WARRANTY
REPAIR PROCEDURE
REPLACE BRAKE LIGHT SWITCH
1.
Open the driver's door.
2.
Move the driver's seat fully rearward.
3.
Remove the installed brake light switch as follows: (Figure 1)
^
Disconnect the brake light switch electrical connector.
^
Rotate the switch 45 degrees counter-clockwise to release the bayonet fitting.
^
Remove the switch from the bracket aperture.
NOTE:
The pedal should have returned to the up-stop but it should not be held by hand against the up-stop.