landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 1800 > < Diagram Information and Instructions|Page 1798
Page 4
background image

Tail door actuator

Pulsed for 0.44 second

Tail window up

Pulsed, drives fully up

Rear wiper

Continuous

Hazard lamps

Continuous

Door open warning

Continuous

Seat belt warning lamp

Continuous

Handbrake/Brake warning lampContinuous
Daytime running lamps

Continuous

Self test mode is cancelled when the ignition is turned off, if oil pressure is sensed (i.e. engine running) or if the vehicle speed exceeds 0.6 mph (1
km/h).

Radio Frequency (RF) Receiver

The RF receiver is part of the security system and relays data from the remote transmitter (plip) to the CCU. The RF receiver is located on top of the
instrument pack, between the housing and the face plate.

Immobilization ECU

The immobilization ECU controls operation of the starter motor to provide the engine immobilization function of the security system. The
immobilization ECU is secured to the rear of the fascia near the vehicle center-line.

Supplementary Restraint System (SRS) Diagnostic Control Unit (DCU)

The SRS DCU controls the operation of the vehicle's airbags and seat belt pretensioners. The SRS DCU is attached to the transmission tunnel below the
heater assembly.

Electronic Automatic Transmission (EAT) ECU (Automatic Gearbox Models Only)

On automatic gearbox models, the EAT ECU controls gear changing and torque converter lockup. The EAT ECU is installed in the Environmental (E)
box in the engine compartment.

Engine Control Module (ECM)

The ECM controls all aspects of engine operation and interfaces with the security system during engine starting. The ECM is installed in the E-box in the
engine compartment.

Cooling Fan ECU

The cooling fan ECU controls the speed of the two cooling fans. The cooling fan ECU is installed in the rear upper left corner of the cooling fan housing.

Anti-lock Braking System (ABS) Modulator

The brake system incorporates an ABS ECU that controls the operation of the hydraulic modulator to provide the ABS, electronic brake force
distribution, traction control and hill descent control functions. The ABS ECU is attached to the hydraulic modulator, which is installed in the front right
corner of the engine compartment.

Folding Door Mirror ECU (Some Markets)

In some markets folding door mirrors are installed and these are controlled by the folding door mirror ECU. The folding door mirror ECU is installed:

^

Up to 2002 MY, on the transmission tunnel, below the center console.

^

From 2002 MY, on the front passenger side 'A' post

Window Lift ECU

The window lift ECU is installed to provide one shot opening of the driver's door window. The window lift ECU is installed on the driver's side A post,
level with the lower edge of the fascia.

Cruise Control Interface ECU (Some KV6 and Td4 Models)

Where fitted, the cruise control interface ECU provides the interface between the cruise control operating system and the cruise control switches on the
steering wheel. The interface ECU is installed under the RH front seat.

Cruise Control ECU (Some KV6 Models)

Diagram Information and Instructions|Page 1800 > < Diagram Information and Instructions|Page 1798