Freelander (LN) V6-2.5L (2004)
14. Tighten the eleven bolts to 8 Nm (6 lbf-ft). (Figure 2)
15. Manually operate the transmission gear selector in both directions to ensure the transmission selector shaft plunger operates correctly.
CAUTION:
The wiring harness must not be trapped behind the connector bracket. The electrical connectors must be fully connected.
16. Visually inspect the wiring harness and ensure correct routing.
17. Connect the valve body electrical connectors. (Figure 1)
18. Refer to the INSTALL FLUID PAN section of this bulletin and install the fluid pan.
19. Install the left-hand front splash shield and secure with the three retaining bolts.
REPLACE SHIFT SOLENOID
1. Refer to the REPLACE VALVE BODY ASSEMBLY section of this bulletin and complete Steps 1-6 to remove the valve body assembly.
2. Disconnect the solenoid electrical connector. (Arrowed in Figure 4)