LR2 (LF) L6-3.2L (2008)
/l6-3.2l/Page-1171001.png)
Ignition Switch: Diagram Information and Instructions
Abbreviations
Understanding the Circuit Diagrams
Understanding The Circuit Diagrams
Components
After each component description, a translation code is displayed in brackets, for example: Starter relay (R102), Engine control module (ECM)(D131).
The codes can be ignored.
NOTE: A dotted outline indicates that the component identified is not shown in its entirety.
Connectors
Connectors and header joints are identified by their corresponding connector number with a numbered suffix to indicate the pinout detail of the wire, i.e.
C0292-1 identifies connector 292, pin number 1. Wire insulation colours are listed in a table at the end of this section. Where wires have a predominant
colour with a secondary colour tracer, the main colour is identified first, i.e. WH-BK - white with a black tracer.
Wire length (Power and Ground Distribution only)
The wire length (in millimeters) is displayed after the colour and cross sectional area; for example, SR,0.35,480. In this example, the figure, 480
indicates the approximate position of the harness splice is 480mm from connector C2335.
Line Types
