LR3/Disco 3
Power Steering Pump - 4.0L (57.20.14)
Removal
Installation
Published : May 12, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the accessory drive belt. For additional information, refer to
Accessory Drive Belt (86.10.03)
(Section 303-05)
3 .
CAUTION: Before the disconnection or removal of any components, ensure the area around
joint faces and connections are clean. Plug any open connections to prevent contamination.
NOTE :
Some oil spillage is inevitable during this operation.
Clamp the power steering pump supply hose to minimise fluid loss.
4 .
Disconnect the high pressure line at the steering pump union.
Position an absorbent cloth to collect fluid spillage.
5 .
Disconnect the power steering pump supply hose.
Release the clip.
6 .
Remove the power steering pump.
Remove the 3 bolts.
1 .
Install the power steering pump.
Clean the component mating faces.
Install and tighten the bolts to 25 Nm (18 lb.ft).
2 .
Connect the power steering supply hose to the steering pump.
Clean the component mating faces.