LR3/Disco 3
D-Pillar Trim Panel (76.13.30)
Removal
Installation
Published : Jun 16, 2004
1 .
Remove the C-pillar lower trim panel. For additional information, refer to
C-Pillar Lower Trim Panel
(76.13.34)
(Section 501-05)
2 .
Vehicles fitted with 7 seats: Release the seat belt.
Remove and discard the bolt.
3 .
Remove the D-pillar upper trim panel.
Release the 4 clips.
Disconnect the electrical connector.
4 .
NOTE :
Do not disassemble further if the component is removed for access only.
Remove the speaker.
Remove the 3 screws.
1 .
To install, reverse the removal procedure.
Tighten the new Torx bolt to 40 Nm (30 lb.ft).