LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-2377002.png)
5. Remove the window motor and regulator assembly.
^
Disconnect the electrical connector.
^
Remove the 4 bolts.
^
Remove the 2 nuts.
^
Rotate the assembly 90 degrees clockwise, to remove the upper part of the assembly from the rear side of the aperture first.
Installation
1. Install the window motor and regulator assembly.
^
Tighten the bolts and nuts to 10 Nm (7 lb.ft).
^
Connect the electrical connector.
2. Secure the glass to the glass regulator.
^
Remove the wedge.
^
Lower the glass.
3. Install the outer waist seal.
4. Install the speaker.
^
Tighten the screws.
^
Connect the electrical connector.
5. Install the rear door trim panel.
