LR3 (LA) V6-4.0L (2006)
^
Remove the bolts and studs. Remove and discard the seals.
Installation
1. Install the bolts and studs.
^
Install the new O-ring seals.
^
Install the new gasket.
2. Install the valve cover.
^
Clean the component mating faces.
^
Evenly and progressively tighten the bolts and studs, in the sequence shown, to 10 Nm (71 ft. lbs.).
^
Secure the electrical harness with the clip.
3. Install the injector harness.
^
Secure with the clips.
^
Connect the fuel injector electrical connectors.
4. Install the fuel rail.
5. Connect the battery ground cable.