LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-650003.png)
3. Using the special tool, install the crankshaft pulley.
^
Lubricate the seal with clean engine oil.
^
Remove the special tool.
4.
CAUTION: The screw thread in the crankshaft pulley must be cleaned out before installing a new crankshaft pulley bolt.
Install, but do not tighten, a new crankshaft pulley bolt.
5. Tighten the crankshaft pulley bolt.
^
Install the special tool.
^
Tighten the bolt to 45 Nm (33 ft. lbs.).
^
Tighten the bolt a further 85 degrees.
^
Remove the special tool.
6. Install the accessory drive belt.
7. Connect the battery ground cable.
