LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-722003.png)
connections to prevent contamination.
Remove the dipstick tube.
^
Remove the dipstick.
^
Remove the bolt.
^
Discard the O-ring seal.
9. Remove the exhaust manifold.
^
Remove the 6 nuts.
^
Remove and discard the gasket.
Installation
All vehicles
1. NOTE: The exhaust manifold gasket connecting links must be positioned to the lower edge of the manifold.
Install the exhaust manifold.
^
Install a new gasket.
^
Clean the component mating faces.
^
Tighten the nuts evenly in the sequence shown to 25 Nm (18 ft. lbs.).
2. Install the dipstick tube.
^
Clean the component mating faces.
^
Install a new O-ring seal.
^
Lubricate the seal with clean engine oil.
^
Tighten the bolt to 10 Nm (7 ft. lbs.).
^
Install the dipstick.
3. Connect the HT electrical connectors.
4. Install the EGR pipe.
^
Clean the component mating faces.
^
Initially, finger tighten the nuts.
^
Finally, tighten the nuts to 40 Nm (30 ft. lbs.).
5. Lower the engine onto its mount.
^
Tighten the nut to 90 Nm (66 ft. lbs.).
6. Raise the vehicle.
7. Install the exhaust system.
^
Clean the component mating faces.
^
Install new bolts and tighten to 40 Nm (30 ft. lbs.).
8. Install the engine undershield.
9. Lower the vehicle.
Right-hand drive vehicles
1. NOTE: Apply petroleum jelly to the battery terminals.
