LR3 (LA) V6-4.0L (2006)
11. Remove the A/C compressor mounting bracket.
^
Remove the 2 bolts.
12. Remove the A/C compressor.
Installation
1. Position the A/C compressor to the engine.
^
If a new compressor is being installed, the required amount of refrigerant oil must be drained from it.
2. Install the A/C compressor mounting bracket.
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
3. Secure the A/C compressor.
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
4. Connect the A/C clutch electrical connector.
CAUTION: Lubricate the new seals with clean refrigerant oil.
5. Connect the refrigerant lines.
^
Clean the component mating faces.
^
Install the new O-ring seals.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
6. Install the front wheel.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
7. Lower the vehicle.
8. Install the oil level indicator and tube.
9. Install the accessory drive belt tensioner.
^
Tighten the bolt to 40 Nm (30 ft. lbs.).
10. Install the accessory drive belt.
11. Fill the A/C system.
12. Connect the battery ground cable.