LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-2665001.png)
Brake Light Switch: Service and Repair
Stoplamp Switch
Removal
CAUTION: The brake pedal MUST NOT be depressed during this operation. Failure to comply will result in damage to the stoplamp switch.
1. Remove the closing trim panel.
^
Release the clip.
^
Remove the 2 screws.
^
Disconnect the electrical connector.
2. Remove the stoplamp switch.
^
Disconnect the electrical connector.
^
Rotate the switch clockwise.
Installation
CAUTION: The brake pedal MUST NOT be depressed during this operation. Failure to comply will result in damage to the stoplamp switch.
1. Install the stoplamp switch.
^
Rotate the switch counterclockwise.
^
Connect the electrical connector.
2. Install the closing trim panel.
^
Connect the electrical connector.
^
Secure the clip.
^
Tighten the screws.
