LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-515002.png)
^
Remove the 4 bolts.
7. Place a container under the transmission.
8. WARNING: Observe due care when draining transmission fluid as the fluid can be very hot.
WARNING: Observe due care when working near a hot exhaust system.
CAUTION: The gearbox fluid level must only be checked when the temperature of the fluid is between 30 degrees and 50 degrees. The fluid
level obtained will be incorrect if the reading is outside this temperature range.
Remove the transmission fluid filler/level plug.
^
Clean the area around the filler/level plug.
^
Remove and discard the sealing washer.
9. If no fluid loss is apparent when the filler/level plug is removed, with the engine at idle, continue to fill the transmission until a small thread of oil
runs from oil filler/level hole.
10. Install the transmission fluid filler/level plug and tighten to 35 Nm (26 ft. lbs.).
^
Install a new sealing washer.
^
Remove the container.
11. If installed, install the transmission heat shield.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
12. Install the transmission undershield.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
13. Disconnect T4 from the vehicle.
