LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-872001.png)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
Engine Coolant Temperature (ECT) Sensor (18.30.10)
Removal
1. Disconnect the battery ground cable.
2. Remove the throttle body gasket.
3. Remove the ECT sensor.
^
Position an absorbent cloth to collect fluid spillage.
^
Disconnect the electrical connector.
^
Remove and discard the O-ring seal.
Installation
1. To install, reverse the removal procedure.
^
Clean the components.
^
Tighten the ECT sensor to 18 Nm (13 ft. lbs.).
^
Top-up the coolant.
