LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-1105001.png)
Knock Sensor: Service and Repair
Knock Sensor (KS) LH
Knock Sensor (KS) LH
Service Repair No - 18.30.28
Removal
1. Disconnect the battery ground cable.
2. Remove the KS.
^
Disconnect the electrical connector.
^
Release the knock sensor electrical connector retaining clips.
^
Remove the bolt.
Installation
1. To install, reverse the removal procedure.
^
Clean the component mating faces.
^
Tighten the bolt to 20 Nm (15 ft. lbs.).
