LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-242002.png)
Installation
1. Make sure the wheel speed sensor location in the wheel knuckle is free of dirt.
2. Install the wheel speed sensor.
^
Attach the wiring harness to the 4 clips.
3. Secure the wheel speed sensor to the wheel knuckle.
^
Tighten the bolt to 9 Nm (7 ft. lbs.).
^
Attach the wiring harness to the clip.
4. NOTE: Make sure the electrical connector retaining clip is attached to the body wiring harness.
Connect the ABS sensor electrical connector.
^
Attach the wiring harness.
5. If a new wheel speed sensor has been installed, interrogate the ABS system using T4.
