LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-432005.png)
9.
Slide a section of "heatshrink" sleeving over vehicle harness wire. (Figure 4)
NOTE:
The crimping tool must be set to the correct jaw size for the Butt Splice wiring connector used.
10.
Crimp the vehicle harness wire to one end of the Butt Splice connector. (Figure 4)
11.
Locate the corresponding pin wire of the overlay harness.
12.
Cut the overlay harness wire to an equal length of wire cut from the vehicle sensor connector.
