LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-1581002.png)
2.
Visually inspect for obvious mechanical faults:
^
Gear selector lever cable adjustment
^
Engine (turns freely)
^
Starter motor pinion gear damaged, seized
^
Flywheel/drive plate ring gear damaged
3.
Visually inspect for obvious electrical faults:
^
Battery state of charge
^
Incorrect battery fitted
^
Fuses
^
Starter relay
^
Wiring Harness(es) and connectors
^
Damaged, loose or corroded battery or starter cables and connections
^
Damaged, loose or corroded engine ground cable and connections
^
Ignition switch
^
Generator
^
Engine control module (ECM)
^
Transmission control module (TCM)
4.
If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
CAUTION:
A Midtronics PSC-550 Vehicle Power Supply must be connected to the vehicle battery during diagnosis.
5.
Connect the Midtronics PSC-550 power supply to the vehicle battery.
6.
Connect IDS to the vehicle and begin a new diagnostic session by entering the correct VIN for the current vehicle.
7.
Use the approved diagnostic system or a scan tool to retrieve any diagnostic trouble codes (DTCs) before moving onto the symptom chart or DTC
index.
8.
Make sure all DTCs are cleared following rectification.
9.
Disconnect diagnostic equipment.
STARTER DIAGNOSIS AND TESTING TABLE
