LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-1209002.png)
8. Remove the transmission heat shield bracket.
^
Remove the 4 bolts.
9. Drain the transmission.
10. CAUTION: Protect the engine during this operation.
Raise the RH side of the engine by approximately 15 mm.
^
Remove the nut. Use a transmission jack.
11. Remove the fluid pan.
^
Position a container to collect the fluid spillage.
^
Remove the 21 Torx screws.
^
Remove and if necessary, discard the seal.
^
Discard the O-ring seal.
Installation
1. Install the fluid pan.
^
Clean the components.
^
Install the seal.
^
Install a new O-ring seal.
^
Tighten the Torx screws to 8 Nm (6 ft. lbs.).
2. Lower the RH side of the engine.
^
Remove the engine support.
^
Tighten the nut to 90 Nm (66 ft. lbs.).
3. Install the transmission heat shield bracket.
