LR3 (LA) V6-4.0L (2006)
/v6-4.0l/Page-1225002.png)
4. Release the selector cable and lever.
^
Remove the nut.
^
Compress the latch and release the cable.
5. CAUTION: Before the disconnection or removal of any components, ensure the area around joint faces and connections are clean. Plug any open
connections to prevent contamination.
Remove the selector shaft seal.
^
Install 307-509-1 to the seal.
^
Install 307-509-2 to 307-509-1 and extract the seal.
Installation
1. Using 307-509-3, install the selector shaft seal.
^
Clean the components.
2. Install the selector cable and bracket.
^
Secure with the clip.
^
Tighten the nut to 12 Nm (9 ft. lbs.).
3. Install the transmission heat shield.
^
Install the bolts.
4. LH selector shaft seal only: Install the exhaust system.
