LR3 (LA) V6-4.0L (2006)
Rear Door Window Glass: Service and Repair
Rear Door Fixed Window Glass
Rear Door Fixed Window Glass
Service Repair No - 76.31.31
Removal
1. Remove the rear door window motor and regulator assembly.
2. Lower the rear door glass to the bottom of the door.
^
Remove the wedge.
3. Remove the rear door frame trim.
^
Release the 2 clips.
^
Carefully release the door trim.
4. Carefully remove the inner waist seal.
5. Release the lining from the glass rear channel.
6. Remove the rear door window fixed glass.
^
Remove the grommet.
^
Loosen the Torx screw, but do not remove it completely at this stage.
^
Pull the lower edge of the glass forward to release it from the door frame.
Installation
1. Install the rear door window fixed glass.
^
Make sure the locating peg on the fixed glass has engaged with the door frame.
^
Tighten the Torx screw to 10 Nm (7 lb.ft).
2. Install the channel lining.
3. Install the inner waist seal.
4. Install the door frame trim.
^
Clean the component mating faces.
^
Remove backing tape from adhesive strip.
^
Secure the clips.
5. NOTE: Wedge the glass in this position.