LR3 (LA) V8-4.4L (2009)
Front Bumper Cover / Fascia: Service and Repair
Front Bumper Cover
Service Repair No - 76.22.72
Removal
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the fender mouldings.
3. Remove the 14 front bumper cover screws.
4. NOTE: Some fluid spillage is inevitable during this operation.
Remove the front bumper cover.
^
Disconnect the 2 electrical connectors.
^
Release the head lamp washer jet hose from the washer pump.
^
Allow the fluid to drain into a container.
5. NOTE: Do not disassemble further if the component is removed for access only.
Remove the washer jets.
6. Remove the parking aid sensors.
^
Disconnect the electrical connector.
^
Release the 2 clips.
^
Repeat the above procedure for the remaining 3 sensors.
7. Remove the parking aid sensor wiring harness.
^
Remove the 9 securing straps.