LR3 (LA) V8-4.4L (2009)
Sunroof / Moonroof Module: Service and Repair
Roof Opening Panel Module
Service Repair No - 76.84.46
Removal
1. Remove the rear overhead console.
^
Carefully release the 9 clips.
^
Disconnect the 2 electrical connectors.
2. Remove the roof opening panel module.
^
Slide the module to the LH side to release it from the bracket.
^
Disconnect the 2 electrical connectors.
Installation
1. Install the roof opening panel module.
^
Connect the electrical connectors.
^
Secure the module to the bracket.
2. Install the rear overhead console.
^
Connect the electrical connectors.
^
Carefully secure the clips.
3. Using T4, configure a new roof opening panel module.
4. If the battery has been disconnected, the one touch and anti-trap function will become inoperative. Close the roof opening panel and continue to
hold the switch for a further 20 seconds to allow the sunroof to complete a full cycle. This will complete the roof opening panels calibration
routine and reset these functions.